Output:
Output Volt Amp Capacity: 3000 VA
Output kVA Capacity: 3kVA
Output Watts Capacity: 2400W
Output kW Capacity: 2.4kW
Output Capacity Details: OVERLOAD CAPACITY: Supports inverter operation up to 105% load continuously, 125% load for 3 minutes 150% load for 30 seconds and >150% load for 0.5 seconds before switching to BYPASS (when bypass input voltage and frequency are WITHIN bypass limits) or SHUTDOWN (when bypass input voltage or frequency are OUTSIDE bypass limits)
Power Factor: 0.8
Crest Factor: 3:1
Nominal Output Voltage Supported: 110V / 120V
Nominal Voltage Details: 120V Default
Frequency Compatibility: 50/60Hz
Frequency Compatibility Details: Output frequency matches input nominal on startup, defaults to 60 Hz on cold-start
Output Voltage Regulation (Line Mode): +/-2%
Output Voltage Regulation (Economy Line Mode: +/10%
Output Voltage Regulation (Battery Mode): +/-2%
Output Receptacles: Hardwire
Output AC Waveform (AC Mode): Sine Waves
Output AC Waveform (Battery Mode): Pure Sine Wave

Input:
Rated Input Current (Maximum Load): 24A
Nominal Input Voltage Supported: 110V AC, 120V AC
UPS Input Connection Type: Hardwire
Recommended Electrical Service: 30A 120V (L-N-G)
Input Phase: Single-Phase

Battery
Full Load Runtime (min): 12 min (2400W)
Half Load Runtime (Min): 30 min (1200w)
Expandable Battery Runtime: Supports Extended Runtime with Optional External Battery Packs
External Battery Pack Compatibility: BP72V15-2U(limit 1) BP72V28RT-3U(multi-pack compatible) BP72V18-2US(multi-pack compatible)
DC System Voltage (VDC): 72
Battery Recharge Rate (Included Batteries): Less than 6 hours from 10% to 80% (typical, full load discharge)
Internal UPS Replacement Battery Cartridge: Front Panel, Battery Access Door
Battery Replacement Description: Hot-Swappable, User Replaceable Batteries
Expandable Runtime: Yes

Voltage Regulation
Voltage Regulation Description: Online, double-conversion power conditioning
Overvoltage Correction: 2% output voltage regulation during overvoltages to 150
Undervoltage Correction: 2% output voltage regulation during undervoltages to 80
Severe Undervoltage Correction: 2% output voltage regulation during undervoltages to 65 (under 70% load only)

User Interface, Alerts and Controls
Switches: 2 Switches control off/on power status and alarm-cancel/self-test operation
Alarm Cancel Operation: Power-fail alarm can be silenced using alarm-cancel switch
Audible Alarm: Audible alarm indicates UPS startup, power-failure, low-battery, overload, UPS fault and remote shutdown conditions
LED Indicators: 14 LEDs indicate line power, online mode, economy/bypass mode, on-battery, overload, battery low, replace battery and fault status information 4-LED meter displays load and battery charge levels LED panel rotates for viewing in rack/tower formats

Surge/Noise Suppression
UPS AC Suppression Joule Rating: 480
UPS AC Suppression Response Time: Instantaneous
UPS Dataline Suppression: 1 line TEL/DSL (1 in / 1 out) 10/100Base T Ethernet
EMI/RFI AC Noise Suppression: Yes

Physical
Included Mounting Accessory Description: Includes 4 post rackmount installation accessories
Installation Form Factors Supported with Optional Accessories: 2 post rackmount(2POSTRMKITHD) Tower(2-9USTAND)
Optional Mounting Accessory Notes: Wallmount Installation Not Recommended
Primary Form Factor: Rackmount
Rack Height: 3U
Cooling Method: Fan
UPS Housing Material: Steel

Environmental
Operating Temperature Range: +32 to +104 degrees Fahrenheit / 0 to +40 degrees Celsius
Storage Temperature Range: +5 to +122 degrees Fahrenheit / -15 to +50 degrees Celsius
Relative Humidity: 0 to 95%, non-condensing
AC Mode BTU /HR (Full Load): 1112.7
AC Economy Mode BTU / HR. (Full Load): 253
Battery Mode BTU/HR (Full Load): 1219.3
AC Mode Efficiency Rating (100% Load) 88%
AC Economy Mode Efficiency Rating (100% Load): 97%

Communications
Communications Interface: USB (HID enabled) DB9 Serial Contact closure EPO (emergency power off) Slot for SNMP/Web interface
Network Monitoring Port Description: Supports detailed monitoring of UPS and site power conditions DB9 port supports RS232 and contact closure communications
PowerAlert Software: Included
Communication Cable: USB and DB9 Cabling Included
WatchDog Time Compatibility: Supports Watchdog application, OS and hard-reboot restart options for remote applications

Line/Battery Transfer
Transfer Time: No Transfer Time (0ms) in Online, Double Conversion Mode
Low Voltage Transfer to Battery Power (Setpoint): 80V (100% Load), 65V (<70% Load)
High Voltage Transfer to Battery Power (Setpoint): 150

Certifications
UPS Certification: Tested to UL1778 (USA) Tested to CSA (Canada) Tested to NOM (Mexico) Meets FCC Part 15 Category A (EMI)

Item Dimension (L"xW"xH")
12 x 32 x 23

Weight
149.90 lb

Warranty Information
2 Years Limited